Panasonic KX-HDV430 - Page 12

For details about configuring network settings via the Web user interface, see 4.3.1 Basic Network
Settings.
To configure IP Mode (IPv4, IPv6, IPv4&IPv6)
1.
In standby mode, tap
or to select "System Settings".
2.
Tap "System Settings".
3.
Tap "Network Settings".
4.
Tap
or to select "IP Mode Select".
5.
Tap "IP Mode Select".
6.
Tap "IPv4"/"IPv6"/"IPv4&IPv6".
• The initial value is "IPv4".
Configuring the Network Settings Using IPv4
To configure network settings automatically
1.
In standby mode, tap
or to select "System Settings".
2.
Tap "System Settings".
3.
Tap "Network Settings".
4.
Tap or to select "IPv4 Settings".
5.
Tap
or to select "Connection Mode".
6.
Select "DHCP", and then tap "OK"
7.
Tap or to select "DNS".
8.
Select "Auto", and then tap "OK".
• Select "Manual" to enter the addresses for DNS1 (primary DNS server) and, if necessary, DNS2
(secondary DNS server) manually, and then tap "OK".
To configure network settings manually
1.
In standby mode, tap or to select "System Settings".
2.
Tap "System Settings".
3.
Tap "Network Settings".
4.
Tap or to select "IPv4 Settings".
5.
Tap or to select "Connection Mode".
6.
Select "Static", and then tap "OK"
7.
Enter the IP address, subnet mask, default gateway, DNS1 (primary DNS server), and, if necessary,
DNS2 (secondary DNS server), and then tap "OK".
Configuring the Network Settings Using IPv6
To configure network settings automatically using DHCP
1.
In standby mode, tap or to select "System Settings".
2.
Tap "System Settings".
3.
Tap "Network Settings".
1.1.3 Basic Network Setup
12 Administrator Guide Document Version 2016-05