• When "?!" is specified, applicable parameter values are managed as carrier default values when applied
to operational information.
* Carrier default values are applied once a reset to carrier defaults is executed. Carrier defaults will also
be initialized when a reset to device defaults is executed.
* Once "?!" is specified, the parameter in question will be designated as a carrier default even if said
parameter is configured without "?!". (This setting will remain in place until restored to factory default.)
Specification of Multiple Parameter Extensions
• One parameter can be assigned multiple extensions.
Example: XXX?R?!="" / XXX?!?r=""
Parameter Extension Configuration Example
1.
In the configuration file, set IP Addressing Mode to IPv4 and Read-Only
Example parameter: IP_ADDR_MODE?R="0" ("0": IPv4)
2.
If an error occurs when attempting to set the IP Mode to IPv6, see To configure IP Mode (IPv4, IPv6,
IPv4&IPv6) in Configuring the Network Settings of the Unit.
2.5 Configuration File Examples
The following examples of configuration files are provided on the Panasonic Web site (→ see Introduction).
• Simplified Example of the Configuration File
• Comprehensive Example of the Configuration File
2.5.1 Examples of Codec Settings
Setting the Codec Priority to (1)G.729A, (2)PCMU, (3)G.722
## Codec Settings
# Enable G722
CODEC_ENABLE0_1="Y"
CODEC_PRIORITY0_1="3"
# Disable PCMA
CODEC_ENABLE1_1="N"
# Enable G729A
CODEC_ENABLE3_1="Y"
CODEC_PRIORITY3_1="1"
# Enable PCMU
CODEC_ENABLE4_1="Y"
CODEC_PRIORITY4_1="2"
Setting Narrow-band Codecs (PCMA and G.729A)
## Codec Settings
# Disable G722
CODEC_ENABLE0_1="N"
# Enable PCMA
CODEC_ENABLE1_1="Y"
CODEC_PRIORITY1_1="1"
# Enable G729A
CODEC_ENABLE3_1="Y"
CODEC_PRIORITY3_1="1"
# Disable PCMU
CODEC_ENABLE4_1="N"
2.5 Configuration File Examples
Document Version 2016-05 Administrator Guide 41
To Next Page
Loading...
