Default Value Not stored.
Note
• When a user logs in to the Web user interface for the first time,
after clicking OK on the authentication dialog box, the [Initial
User Password Settings] screen is displayed automatically to
make the user set a password.
Configuration File Reference USER_PASS
Confirm New Password
Description Specifies the same password that you entered in [New Password]
for confirmation.
Value Range 6–64 characters (except !, ", #, $, %, &, ', (, ), @, *, +, ,, /, :, ;, <, =,
>, ?, [, ], ^, `, {, |, }, ~, \ and space)
Default Value Not stored.
4.4.3 Admin Password Settings
This screen allows you to change the password used to authenticate the Administrator account when
logging in to the Web user interface.
Note
• For security reasons, the characters entered for the password are masked by special characters,
which differ depending on the Web browser.
• After you change the administrator password, the next time you access the Web user interface, the
authentication dialog box appears. Three consecutive login failures will result in an error ("401
Unauthorized"). This restriction only applies the first time you attempt to log in after changing the
password. In all other circumstances, an error occurs after 3 unsuccessful login attempts.
4.4.3.1 Admin Password
Current Password
Description Specifies the current password to use to authenticate the
Administrator account when logging in to the Web user interface.
4.4.3 Admin Password Settings
Document Version 2016-05 Administrator Guide 93
To Next Page
Loading...
