Value Range 1 or 2 (× 10 ms)
Note
• This setting is subject to the following conditions:
– This value must be less than or equal to "NOM_DELAY"
– This value must be less than "MAX_DELAY"
– "MAX_DELAY" must be greater than "NOM_DELAY"
Default Value 2
NOM_DELAY_n
Parameter Name Example NOM_DELAY_1, NOM_DELAY_2, …, NOM_DELAY_16
Value Format INTEGER
Description Specifies the initial delay, in 10-millisecond units, of the jitter buffer.
Value Range 1–7 (× 10 ms)
Note
• This setting is subject to the following conditions:
– This value must be greater than or equal to "MIN_DELAY"
– This value must be less than "MAX_DELAY"
Default Value 1
RTP_PORT_MIN
Value Format INTEGER
Description Specifies the lowest port number that the unit will use for RTP
packets.
Value Range 1024–59598 (only even)
Default Value 16000
Web User Interface Reference Minimum RTP Port Number
RTP_PORT_MAX
Value Format INTEGER
Description Specifies the highest port number that the unit will use for RTP
packets.
Value Range 1424–59998 (only even)
Default Value 20000
Web User Interface Reference Maximum RTP Port Number
RTP_PTIME
Value Format INTEGER
Description Specifies the interval, in milliseconds, between transmissions of RTP
packets.
5.3.26 RTP/RTCP/RTCP-XR Settings
Document Version 2016-05 Administrator Guide 257
To Next Page
Loading...
