Description Specifies whether the reorder tone is repeated.
Value Range 0–1
– 0: No Repeat
– 1: Repeat
Default Value 1
REORDER_TONE_TIMING
Value Format Comma-separated Integer
Description Specifies the pattern, in milliseconds, of reorder tones using up to 10
whole numbers (off 1, on 1, off 2, on 2…) separated by commas.
Note
• It is recommended that you set a value of 60 milliseconds or
more for the first value (off 1).
Value Range 0–16000 (0: Continuous)
Note
• Avoid setting 1–50 for any of the values.
Default Value 60,250,190
Web User Interface Reference Tone Timings
RINGBACK_TONE_FRQ
Value Format Comma-separated Integer
Description Specifies the dual-tone frequencies, in hertz, of ringback tones using
2 whole numbers separated by a comma.
Value Range 0, 200–2000 (0: No tone)
Default Value 440,480
Web User Interface Reference Tone Frequencies
RINGBACK_TONE_GAIN
Value Format INTEGER
Description Specifies the gain, in decibels, of the ringback tone.
Value Range -24–24 (dB)
Default Value 0
RINGBACK_TONE_RPT
Value Format INTEGER
Description Specifies whether the ringback tone is repeated.
Value Range 0–1
– 0: No Repeat
– 1: Repeat
5.3.33 Tone Settings
280 Administrator Guide Document Version 2016-05
To Next Page
Loading...
