® 6.1 [4-1-1] Wired Extension—Extension Settings—Intercept No Answer Time— Intercept No Answer
Time—Day, Lunch, Break, Night
• The Intercept Routing destination
for each time mode will not apply for Intercept Routing—Busy. When the
original destination is busy, the call is redirected to the Intercept Routing—Busy destination assigned
through system programming. If no destination is assigned the caller will hear a busy tone.
• The time modes that are selected for CO line calls arriving at extensions and VM groups are decided on
a tenant basis.
• Intercept for calls to an outside destination
– Channels of a T1 CO line set to LCOT type do not support this feature.
– This feature may not be available depending on the specifications of the telephone network.
– This feature is not available when the original call was made from a SIP extension.
PC Programming Manual References
4.5 [2-3] Timers & Counters
→Dial / IRNA / Recall / Tone—
Intercept Routing No Answer (IRNA)—Day, Lunch, Break, Night
→DISA / Door / Reminder / U. Conf— DISA—Intercept Timer—Day, Lunch, Break, Night
5.12 [3-5-1] Incoming Call Distribution Group—Group Settings
→Overflow No
Answer—
Time out & Manual Queue Redirection—Destination-Day, Lunch, Break, Night
6.1 [4-1-1] Wired Extension—Extension Settings
→Intercept Destination
→Intercept No Answer Time
6.10 [4-2-1] Portable Station—Extension Settings
→Intercept Destination
→Intercept No Answer Time
7.3 [5-3-1] Voice Message—DISA System
—Option 1—
DISA Intercept—Intercept when all DISA
ports are
busy
12.6 [10-4] Miscellaneous
→
Intercept—Intercept Routing - DND (Destination sets DND.)
→ Intercept—Routing to Operator - No Destination (Destination is not programmed.)
→ Intercept—Intercept Routing for Extension Call
PT Programming Manual References
[203] Intercept Time
[604] Extension Intercept Destination
[625] Destination for Overflow Time Expiration
Feature Manual References
4.1.8 DISA (Direct Inward System Access)
4.1.10 DND (Do Not Disturb)
9.1.12 Intercept Routing—No Destination
Description
Directs a CO line call to an operator when the call has no assigned destination.
Document Version 2013-05 Feature Manual 177
9.1.12 Intercept Routing—No Destination
To Next Page
Loading...
