Panasonic KX-NCP500 - SMDR (Station Message Detail Recording)

Conditions
[General]
• The availability of this feature depends on the SIP service provider.
• Since the SIP service provider takes control of the transfer, the transferred call cannot be returned to the
PBX for further handling even if the transfer fails.
[Blind Transfer]
• SIP extensions cannot use this feature.
• This feature cannot be used when calling through DISA
(® 4.1.8 DISA (Direct Inward System Access)).
Installation Manual References
KX-NCP500/KX-NCP1000
3.4.1 Virtual Cards
KX-TDE100/KX-TDE200
3.4.1 Virtual Cards
KX-TDE600
3.4.1 Virtual Cards
Operating Manual References
1.3.11 Call Transfer—
Transferring to an Outside Party Using the SIP Service
Other References
Programming Manual for Virtual SIP CO Line Card
3.1.13 Supplementary Service
→Blind Transfer (REFER)
→Attended Transfer (REFER)
16.1.4 SMDR (Station Message Detail Recording)
Description
Automatically logs detailed information for each extension.
1. SMDR Output Port
The following output methods can be selected through system programming:
13.1 [11-1] Main—SMDR— SMDR Format—Port
Output Method Description
Serial Interface (RS-232C) port SMDR information is sent to a connected PC, printer, etc.
Telnet compatible terminal emulator SMDR information is sent to a Telnet compatible terminal
emulator via LAN.
2. SMDR Output Data
The following data can be recorded and sent to the SMDR output port:
a. CO line call information (incoming/outgoing)
b. Intercom call information (outgoing)
Document Version 2013-05 Feature Manual 311
16.1.4 SMDR (Station Message Detail Recording)