Panasonic KX-NCP500 - Page 19

Since the preferred carrier may vary depending on the time of day, you can create an ARS-specific time
table and break each day of the week into different time blocks. A different carrier can then be assigned
to each time block.
Routing Plan Time Table:
For each Routing Plan, a different carrier can be assigned for each time of day
and each day of the week. Each day can have up to four programmable time blocks.
Routing Plan Priority: For each Routing Plan, a different carrier can be assigned a different priority for
each time of day. Generally, the carrier assigned to priority 1 will be used, however, if the CO lines assigned
to this carrier are busy, a different available carrier will be used according to priority level.
ARS Leading Number Table
ARS Routing Plan No. 1
1
2
3
Location
No.
1212
01181
01144
Leading
No.
7
0
0
1
5
12
Additional No.
of Digits
Routing Plan
No.
Monday
Time Table
*1
Carrier
*2
Time Block A
Time Block B
Time Block C
Time Block D
Priority 1
Carrier A
Carrier A
Carrier C
Carrier J
Priority 2
Carrier M
Carrier M
Carrier M
Carrier M
9:00
12:00
17:00
23:00
*1
® 10.4 [8-3] Routing Plan Time—Time Setting
® [330] ARS Routing Plan Time Table
*2
® 10.5 [8-4] Routing Plan Priority
® [331–346] ARS Routing Plan Table (1–16) (KX-NCP500/KX-NCP1000/KX-TDE100/KX-TDE200 only)
® [347] ARS Routing Plan Table (1–48)
5. Carrier Table
Each carrier must be programmed in the Carrier Table. Here each carrier is assigned a carrier number,
name, the CO lines it is used with, etc.
®
10.6 [8-5] Carrier—Carrier
Carrier Name: Assign a name for the carrier. Used only as a reference.
Trunk Group: Assign the trunk groups which can be used when making calls via this carrier and the priority
in which they are selected. When using PC programming, trunk groups can be assigned to a carrier using
an on/off setting for each trunk group. They can also be given a priority setting (1–4) which decides the
order they are searched when seizing a line. If there are no available lines in the trunk groups set to priority
1–4, the other trunk groups set to on are searched in the order of smallest number first.
[Example]
Carrier
Priority Setting
Trunk Groups Set
to On
Searching Order
1 2 3 4
ABC 9 3 1 7 5, 7, 9, 11
9 ® 3 ® 1 ® 7 ® 5 ® 11
XYZ 12 4 None None 6, 10
12 ® 4 ® 6 ® 10
Carrier Access Code: Enter the carrier’s access code. Consult carrier for details.
Document Version 2013-05 Feature Manual 19
1.1.3 ARS (Automatic Route Selection)