[Example]
105:Tom Smith
--- Extension no. and name of who left the message
This extension
Other extension*
* This button is useful, for
example, when a secretary
checks messages left for the
boss (Boss & Secretary Feature).
ICD Group
Message buttons
Conditions
• Message Button
Any flexible button can be assigned as a Message button. This button can be used on a PT which does
not have the MESSAGE
button (fixed button), or can be used on any PT to access messages left for another
extension or for an incoming call distribution (ICD) group.
• Distinctive Dial Tone for Message Waiting
If Distinctive Dial mode is enabled, dial tone 4 will be sent to an extension when a message has been left
on the extension. (® 4.1.4 Dial Tone)
• SLT with a Message Waiting Lamp (KX-TDE series only)
The lamp activates in the same way as the MESSAGE button on a PT, if an EMSLC, MSLC, or MCSLC
card is connected to the PBX. The preferred Message Waiting Lamp light pattern can be selected from the
twelve patterns shown below. System programming for each extension port is required to use this feature.
198 Feature Manual Document Version 2013-05
11.1.3 Message Waiting
To Next Page
Loading...
