Pattern 11
Pattern 12
ON
OFF
ON
OFF
t=1.28 s
10.24 s 10.24 s 20.48 s
t
t=1.28 s
10.24 s 10.24 s 20.48 s
t
• It is possible to leave a Message Waiting notification while hearing a ringback tone, busy tone, or DND
tone.
• Messages are always left
on the original destination extension, regardless of that extension’s FWD settings.
(® 6.1.6 FWD (Call Forwarding))
• Both the calling extension and the called extension can cancel a notification after it has been left.
• If the extension that received a notification calls back the extension that sent the notification, and the call
is answered, the notification will be cleared automatically. However, if a voice message has been left on
the VPS, whether the notification is cleared or not depends on the VPS settings.
• If a voice message has been left on the VPS for a SIP extension (except KX-HGT100), the lamp will not
turn on.
Installation Manual References
KX-NCP500/KX-NCP1000
None
KX-TDE100/KX-TDE200
3.6.7 SLC16 Card (KX-TDA0174), MSLC16 Card (KX-TDA0175), and CSLC16 Card (KX-TDA0177)
3.6.8 MCSLC16 Card (KX-TDA1176) and MCSLC24 Card (KX-TDA1178)
KX-TDE600
3.8.7 CSLC16 Card (KX-TDA0177), ESLC16 Card (KX-TDA6174), EMSLC16 Card (KX-TDA6175), ECSLC24
Card (KX-TDA6178), and EMSLC24 Card (KX-TDA6179)
PC Programming Manual References
3.23 [1-1] Slot—Card Property - Extension Type—
SLT Power Supply (KX-TDE series only)
4.9 [2-6-1] Numbering Plan—Main—Features— Message Waiting Set / Cancel / Call Back
4.11 [2-6-3] Numbering Plan—B/NA DND Call Feature— Message Waiting Set
4.18 [2-9] System Options
→Option 3— Dial Tone—Distinctive Dial Tone
→Option 5— SLT—Message Waiting Lamp Pattern (KX-TDE series only)
5.21 [3-8-1] VM(DTMF) Group—System Settings— VM DTMF Command—Listening Message
6.1 [4-1-1] Wired Extension—Extension Settings—Option 8— SLT MW Mode (KX-TDE series only)
6.5 [4-1-4] Wired Extension—Flexible Button— Type
6.13 [4-2-3] Portable Station—Flexible Button— Type
6.18 [4-3] DSS Console— Type
200 Feature Manual Document Version 2013-05
11.1.3 Message Waiting