Number in
the Pattern
Data Description
(9) CD (Condition
Code)
Shows other call information using the following codes:
TR: Transfer
FW: Call Forwarding (FWD) to CO line
D0: Call using Direct Inward System Access (DISA) or TIE line
service
RM: Remote maintenance (modem) (® 13.1.6 PC
Programming)
NA: Not answered call
RC: Received call
AN: Answered call
VR: Received call with Call Waiting Caller ID (Visual Caller ID)
VA: Answered call with Call Waiting Caller ID (Visual Caller ID)
(10) Cost Shows the call charge. This is not available if your telephone
company does not provide a call charge reporting service.
The following data can be controlled through system programming to adjust whether (or how) they are
printed or displayed by SMDR.
[Programmable Items]
Item Description
Outgoing CO line call Controls whether outgoing CO line calls are shown. This setting
is common throughout the PBX. COS programming is also
required.
® 13.1 [11-1] Main—SMDR— Print Information—Outgoing
Call
® [804] SMDR Outgoing Call Printing
Incoming CO line call Controls whether incoming CO line calls are shown.
® 13.1 [11-1] Main—SMDR—
Print Information—Incoming
Call
® [805] SMDR Incoming Call Printing
Outgoing intercom call Controls whether outgoing intercom calls are recorded.
® 13.1 [11-1] Main—SMDR—
Print Information—Intercom
Call
Log-in/Log-out status Controls whether the Log-in/Log-out status of extensions is
recorded.
® 13.1 [11-1] Main—SMDR— Print Information—Log-in /
Log-out
ARS dial Controls whether the user-dialed number or the ARS-modified
number is shown.
The Host PBX Access
code ("=" followed by the access code) can
be shown (as supplementary information) only when the modified
number is selected in this setting. (® 1.1.3 ARS (Automatic
Route Selection))
® 13.1 [11-1] Main—SMDR Options—
Option—ARS Dial
Document Version 2013-05 Feature Manual 315
16.1.4 SMDR (Station Message Detail Recording)
To Next Page
Loading...
