To Next Page
M
Michelle LeeSep 6, 2025
Why can't I use my Panasonic KX-NT700 IP Phone for PS or PC calls?
- TTiffany CannonSep 6, 2025
If you cannot use your Panasonic IP Phone for PS or PC calls, confirm that you are using the correct cable to connect to the device, and that the cable is connected properly. Also, if the operation mode is set to "USB Audio", you cannot make or receive IP, TEL, PS or PC calls, so change the setting to "Peer to Peer" or "IP-PBX". Finally, confirm that "PS" or "PC" is shown in the upper-right corner of the display. Press the center function button to change the line if necessary. Make sure the "Line Selection" setting is set to "IP + PS" (for PS calls) or "IP + PC" (for PC calls).
General
