Panasonic KX-TDA100 - Page 248

Forced Release Pattern
Selects the bit pattern for a forced release signal.
Value Range
A=0/B=0, A=0/B=1, A=1/B=0, A=1/B=1
Maintenance Console Location
3.22 [1-1] Slot—Card Property - E1 type—Line Signal Setting
Programming Manual References
None
Feature Guide References
None
E&M Signalling Type
Selects the control bit of an E & M signal.
Value Range
Type-1:A bit=0, Type-2:A bit=1, Type-3:B bit=0, Type-4:B bit=1, Type-5:A bit=1,B bit=1
Maintenance Console Location
3.22 [1-1] Slot—Card Property - E1 type—Line Signal Setting
Programming Manual References
None
Feature Guide References
None
Wink Signal Width
Specifies the length of a wink signal.
Value Range
32 ´ n (n=4–9) ms
Maintenance Console Location
3.22 [1-1] Slot—Card Property - E1 type—Line Signal Setting
Programming Manual References
None
248 PC Programming Manual
3.22 [1-1] Slot—Card Property - E1 type—Line Signal Setting