Panasonic KX-TDA100 - Page 404

Maintenance Console Location
4.8 [2-6-1] Numbering Plan—Main
Programming Manual References
3.14 [1-1] Slot—Port Property - BRI Port—Supplementary Service— COLP, CLIR, COLR, CNIP, CONP,
CNIR, CONR, CF (Rerouting), CT, CCBS, AOC-D, AOC-E, 3PTY
3.16 [1-1] Slot—Port Property - PRI Port (KX-TDA100/KX-TDA200/KX-TDA600 only)—Supplementary
Service—
COLP, CLIR, COLR, CNIP, CONP, CNIR, CONR, CF (Rerouting), CT, CCBS, AOC-D, AOC-E,
3PTY
Feature Guide References
1.21.1.2 Calling/Connected Line Identification Presentation (CLIP/COLP)
1.30.4.2 Calling/Connected Line Identification Presentation (CLIP/COLP) and Calling/Connected Name
Identification Presentation (CNIP/CONP)
—by QSIG
Switch CLIP of CO Line / Extension
Specifies the feature number used to send either the CLIP number of the trunk in use (subscriber’s number)
or the extension to the network.
Value Range
Max. 4 digits (consisting of 0–9, *, and #)
Maintenance Console Location
4.8 [2-6-1] Numbering Plan
—Main
Programming Manual References
3.14 [1-1] Slot—Port Property - BRI Port—ISDN CO—
Subscriber Number
3.16 [1-1] Slot—Port Property - PRI Port (KX-TDA100/KX-TDA200/KX-TDA600 only)—CO Setting—
Subscriber Number
6.1 [4-1-1] Wired Extension—Extension Settings
—ISDN CLIP— CLIP ID
6.10 [4-2-1] Portable Station—Extension Settings—ISDN CLIP— CLIP ID
Feature Guide References
1.21.1.2 Calling/Connected Line Identification Presentation (CLIP/COLP)
MCID
Specifies the feature number used to ask the telephone company to trace a malicious call. This feature can
be used during a call or while hearing a reorder tone after the caller hangs up.
Value Range
Max. 4 digits (consisting of 0–9, *, and #)
Maintenance Console Location
4.8 [2-6-1] Numbering Plan—Main
404 PC Programming Manual
4.8 [2-6-1] Numbering Plan—Main