1.11.6 Flash/Recall/Terminate
Description
The FLASH/RECALL button (Flash/Recall mode or Terminate mode) or Terminate button (Terminate mode)
is used when a PT user disconnects the current call and originates another call without hanging up first. It
performs the same function as going on-hook and then going off-hook.
[Explanation of Each Mode]
Flash/Recall Mode: Disconnects the line. The extension user hears the dial tone from the line used last. For
example, if a trunk call is disconnected, the extension user will hear a new dial tone from the telephone
company.
Terminate Mode: Disconnects the line. The extension user hears the dial tone determined by the Line
Preference—Outgoing setting. (® 1.5.5.2 Line Preference—Outgoing)
Conditions
• FLASH/RECALL Button Mode
One of the following modes can be selected for each extension through system programming:
– Flash/Recall mode
– Terminate mode
– External Feature Access (EFA) mode. (® 1.11.7 External Feature Access (EFA))
• Terminate Button
A flexible button can be customised as the Terminate button.
• Disconnect Time (Only for Flash/Recall Mode)
The amount of time between successive accesses to the same trunk is programmable for each trunk port.
• This feature outputs an SMDR call record (® 1.26.1 Station Message Detail Recording (SMDR)), restarts
the call timer, inserts the automatic pause, and checks the TRS/Barring level (® 1.9.1 Toll Restriction
(TRS)/Call Barring (Barring)) again.
• The Terminate feature will be performed when pressing the FLASH/RECALL button regardless of the mode
that the FLASH/RECALL button has been set to, in the following situations:
– When a call is made using ARS. (® 1.10.1 Automatic Route Selection (ARS))
– When a trunk call is made with the INTERCOM button.
– When a trunk call is made with an ICD group button.
PC Programming Manual References
3.10 [1-1] Slot—Port Property - LCO Port—
Disconnect Time
3.18 [1-1] Slot—Port Property - T1 Port— Disconnect Time
3.24 [1-1] Slot—Port Property - E1 Port— Disconnect Time
3.27 [1-1] Slot—Port Property - EM Port— Disconnect Time
3.30 [1-1] Slot—Port Property - DID Port— Disconnect Time
6.1 [4-1-1] Wired Extension—Extension Settings—Option 7— Flash Mode during CO Conversation
6.5 [4-1-4] Wired Extension—Flexible Button— Type
6.10 [4-2-1] Portable Station—Extension Settings—Option 7— Flash Mode during CO Conversation
6.13 [4-2-3] Portable Station—Flexible Button— Type
6.17 [4-3] DSS Console— Type
PT Programming Manual References
[418] LCOT Disconnect Time
Feature Guide 153
1.11.6 Flash/Recall/Terminate
To Next Page
Loading...
