1.1.1.7 Intercept Routing—No Destination
Description
Provides automatic redirection of incoming trunk calls that do not have a destination assigned. The intercept
destination is an operator (tenant/PBX).
Conditions
• Intercept Routing—No Destination on/off
The Intercept Routing—No Destination feature can be enabled or disabled through system programming.
If disabled, a reorder tone will be sent to the caller. However, the Intercept Routing—No Destination feature
always functions for calls through the LCOT/CLCOT, or T1 (LCOT/GCOT) card even when disabled.
• If an operator (tenant/PBX) is not assigned:
The extension connected to the lowest-numbered jack will be the intercept destination.
• Intercept Routing—No Destination also applies to calls from doorphones.
PC Programming Manual References
4.3 [2-2] Operator & BGM— PBX Operator—Day, Lunch, Break, Night
12.7 [10-5] Miscellaneous— Intercept—Routing to Operator - No Destination (Destination is not
programmed.)
PT Programming Manual References
[006] Operator Assignment
Feature Guide References
2.2.5 Operator Features
Feature Guide 33
1.1.1 Incoming Trunk Call Features
To Next Page
Loading...
