1.25 Portable Station (PS) Features
1.25.1 Portable Station (PS) Connection
Description
This PBX supports the connection of a PS. Cell Stations (CSs) allow PSs to receive reception within a
designated area. It is possible to use the PBX features using the PS like a PT.
Conditions
[General]
• The PS registration is required through the system programming. To avoid unexpected registration to
another PBX, the Personal Identification Number (PIN) for the PBX is necessary to register a PS. The
registration can be cancelled.
• A PS can only be assigned an extension number of 4 digits or less.
• Handover
Even if a PS user moves during a conversation, the PS will automatically switch between cells without
disconnecting the call (Handover).
Handover is available in any of the following cases:
a. During a conversation with an extension or outside party.
b. While a call is ringing at the PS.
c. While the PS is in idle status.
PBX
CS
Handover:
Calls will not be
disconnected.
CS
CS
Interface
However, Handover is not available in any of the following cases:
a. When the new (Handover) CS is busy.
b. When there is no CS within range.
c. While the Live Call Screening (LCS) or Two-way Record is activated (® 1.24.3 Voice Mail DPT (Digital)
Integration).
d. While the PS user is paging other extensions (® 1.15.1 Paging).
e. During a doorphone call (® 1.17.1 Doorphone Call).
f. While the PS user is dialling digits to make a trunk call.
g. During a conversation with an extension using PC Console or PC Phone, to which the conversation is
being recorded.
h. While participating as a member of a broadcasting call (® 1.16.1 Broadcasting).
• When a caller has dialled the extension number of a PS but the CS is busy, the caller hears a busy tone.
• For more information about connecting PSs to CSs, see the Quick Installation Guide for the relevant CS.
272 Feature Guide
1.25.1 Portable Station (PS) Connection
To Next Page
Loading...
