Panasonic KX-TDA100D

1.29 Audible Tone Features
1.29.1 Dial Tone
Description
The following distinctive dial tones inform extensions about features activated on their extensions.
Each dial tone type has two frequencies (e.g., dial tone 1A and dial tone 1B).
Type
Description
Tone 1A/1B A normal dial tone is heard when:
a. No features listed for dial tones 2 through 4 has been
set, or
b. ARS is used
Tone 2A/2B This tone is heard when:
• There are messages that have previously been listened
to and no new messages on the ESVM card.
*1
• Any of the features below are set.
• Absent Message
• BGM
• FWD
• Call Pickup Deny
• Call Waiting
• DND
• Extension Dial Lock
• Executive Busy Override Deny
• Hot Line
• Timed Reminder
Tone 3A/3B This tone is heard when:
• A called PS is being searched for.
• The recording time used by the Built-in Simplified Voice
Message feature reaches the limit.
*1
• Any of the features below are performed.
• Account Code Entry
• Consultation Hold
• Answering a Timed Reminder call with no message
• Answering a sensor call
Tone 4A/4B This tone is heard when new messages have been recorded
for the extension.
*1
Active even when distinctive dial tones are disabled.
Conditions
• Dial Tone Type A/B
It is possible to select dial tone type A or B for dial tones 1 through 4. If "Type A" is selected, all dial tones
1 through 4 will become dial tone type A.
The dial tone type for the ARS feature can be selected separately. If "Type A" is selected for the ARS,
dial tone 1A will be heard. If "Type B" is selected, dial tone 1B will be heard.
Feature Guide 307
1.29.1 Dial Tone