Note
Tenant number and VM trunk group number can also be assigned in the DIL table. Tenant number is used
to determine the time mode (day/lunch/break/night) for the corresponding trunk. VM trunk group number
is used in Voice Mail DPT (Digital) Integration.
Explanation:
If a trunk call is received from trunk 01;
In Day mode: CLI is enabled. Route to CLI destination.
In Lunch mode: CLI is disabled. Route to DIL destination, extension 100.
PC Programming Manual References
12.2 [10-2] DIL Table & Port Settings—DIL
→ DIL Destination—Day, Lunch, Break, Night
→ Tenant Number
→ VM Trunk Group No.
PT Programming Manual References
[421] BRI DIL/DDI/MSN Selection
[450] DIL 1:1 Destination
Feature Guide References
1.1.1.5 Calling Line Identification (CLI) Distribution
2.2.3 Tenant Service
2.2.4 Time Service
3.1 Capacity of System Resources
Feature Guide 19
1.1.1 Incoming Trunk Call Features
To Next Page
Loading...
