Number in the
Table
Feature Description
(4) Automatic Number
Identification (ANI)
Outgoing ANI:
Sends the caller’s number to the E1 line. The
sending method is the same as ISDN CLIP
service. (® 1.21.1.2 Calling/Connected
Line Identification Presentation (CLIP/
COLP))
Incoming ANI:
Receives the caller’s number from the E1
line.
When the ANI number is received, it can be
treated the same as a Caller ID number.
(® 1.18.1 Caller ID)
(5) Call Charge Information The call charge meter pulses can be
received during a conversation. (®
1.26.3 Call Charge Services)
Conditions
• If an E1 line is used as a trunk, the channel type depends on the contract with the telephone company.
• If "MFC-R2" is selected as the Dial Mode, the PBX always sends a dial tone, instead of the telephone
company, when making a trunk call using E1 line.
PC Programming Manual References
3.24 [1-1] Slot—Port Property - E1 Port
3.25 [1-1] Slot—Port Property - E1 Port—Connection Command
254 Feature Guide
1.22.1 E1 Line Service
To Next Page
Loading...
