Panasonic KX-TDA100D

– Intercept Routing—Busy/DND (when the destination extension is busy or in DND mode)
– Incoming Call Distribution Group—Overflow
Original
destination
Incoming
call
123 54
A B C D E F
In the above illustration, forwarding stops at extension E. However, forwarding can go farther in the
following cases:
– If a destination extension rings, and then the call is redirected to the forward destination by the FWD
—No Answer or Busy/No Answer feature.
– If a destination extension rings, and then the call is redirected to the intercept destination by the
Intercept Routing—No Answer feature.
– If a call waits in a queue of an incoming call distribution group, and then the call is redirected to the
overflow destination by the Queuing Time Table. (® 1.2.2.4 Queuing Feature)
In the above cases, the forwarding counter resets to zero, and the call can be forwarded up to four times
again from the destination extension described above.
Original
destination
Incoming
call
123 21
FWD—No Answer
A B C D E F
• Boss & Secretary feature
It is possible to call the original extension from the destination extension regardless of the forward setting.
FWD—All Calls
Call or
transfer a call
Boss
(Original)
Secretary
(FWD destination)
Incoming
call
• Message Waiting
While calls are forwarded, Message Waiting information is not forwarded. The Message button light turns
on at the originally called extension. (® 1.19.1 Message Waiting)
• Idle Extension Hunting
Idle Extension Hunting applies to calls forwarded to a busy extension in an idle extension hunting group.
[All Calls and Busy]
• If the forward destination is not available to answer a call, this feature is cancelled and the original
destination will ring for the following type of call:
– Doorphone call
– Trunk calls via the LCOT/CLCOT, or T1 (LCOT/GCOT) cards
[No Answer and Busy/No Answer]
• No Answer Time
Feature Guide 69
1.3.1 Call Forwarding (FWD)/Do Not Disturb (DND)