Panasonic KX-TDA30

1.11 Conversation Features
162 Feature Guide
1.11.6 Flash/Recall/Terminate
Description
The FLASH/RECALL button (Flash/Recall mode or Terminate mode) or Terminate button (Terminate mode)
is used when a PT user disconnects the current call and originates another call without hanging up first. It
performs the same function as going on-hook and then going off-hook.
[Explanation of Each Mode]
Flash/Recall Mode: Disconnects the line. The extension user hears the dial tone from the line used last.
For example, if a trunk call is disconnected, the extension user will hear a new dial tone from the telephone
company.
Terminate Mode: Disconnects the line. The extension user hears the dial tone determined by the Line
Preference—Outgoing setting. (→ 1.5.5.2 Line Preference—Outgoing)
Conditions
• FLASH/RECALL Button Mode
One of the following modes can be selected for each extension through system programming:
– Flash/Recall mode
– Terminate mode
– External Feature Access (EFA) mode. (→ 1.11.7 External Feature Access (EFA))
• Terminate Button
A flexible button can be customised as the Terminate button.
• Disconnect Time (Only for Flash/Recall Mode)
The amount of time between successive accesses to the same trunk is programmable for each trunk
port.
• This feature outputs an SMDR call record (→ 1.26.1 Station Message Detail Recording (SMDR)),
restarts the call timer, inserts the automatic pause, and checks the TRS/Barring level (→ 1.9.1 Toll
Restriction (TRS)/Call Barring (Barring)) again.
• The Terminate feature will be performed when pressing the FLASH/RECALL button regardless of the
mode that the FLASH/RECALL button has been set to, in the following situations:
– When a call is made using ARS. (→ 1.10.1 Automatic Route Selection (ARS))
– When a trunk call is made with the INTERCOM button.
– When a trunk call is made with an ICD group button.
Programming Manual References
PC Programming Manual
2.7.11 [1-1] Slot—LCO Port—Disconnect Time
2.7.19 [1-1] Slot—T1 Port (KX-TDA100/KX-TDA200/KX-TDA600 only)—Disconnect Time
2.7.25 [1-1] Slot—E1 Port—Disconnect Time
2.7.28 [1-1] Slot—E&M Port (KX-TDA100/KX-TDA200/KX-TDA600 only)—Disconnect Time
2.7.31 [1-1] Slot—DID Port—Disconnect Time
2.10.1 [4-1-1] Wired Extension—Extension Settings—Option 6—Flash Mode during CO Conversation
2.10.5 [4-1-4] Wired Extension—Flexible Button—Type
2.10.10 [4-2-1] Portable Station—Extension Settings—Option 6—Flash Mode during CO Conversation
2.10.13 [4-2-3] Portable Station—Flexible Button—Type
2.10.17 [4-3] DSS Console—Flexible Button—Type