Panasonic KX-TDA30

1.1 Incoming Call Features
Feature Guide 41
1.1.3.2 Ring Tone Pattern Selection
Description
It is possible to select the type of ring tone pattern that arrives at an extension for each type of incoming call,
etc.
[Ring Tone Patterns]
[Ring Tone Pattern Table]
The ring tone pattern table is categorised into three parts, each containing a specified number of pattern
plans.
The ring tone pattern table is categorised as follows:
• Incoming Trunk Calls: each pattern plan can assign a ring tone pattern for each trunk group.
→ 2.8.14 [2-8-1] Ring Tone Patterns—Call from CO
• Incoming Doorphone Calls: each pattern plan can assign a ring tone pattern for each doorphone.
→ 2.8.15 [2-8-2] Ring Tone Patterns—Call from Doorphone
• Others: each pattern plan can assign a ring tone pattern for incoming intercom calls as well as ring
tones assigned to certain features (e.g., timed reminder).
→ 2.8.16 [2-8-3] Ring Tone Patterns—Call from Others
The ring tone patterns that arrive at an extension are determined by the pattern plan that is assigned to that
extension through system programming.
[Programming Example of Ring Tone Pattern Table]
Conditions
•"PT Ring off Setting" can be enabled or disabled through system programming. If disabled, PT
users cannot turn incoming call ringing off for their extension.
*: The duration of a ring tone may vary by country/area.
Table
No.
Intercom
Call/Hold
Recall
Trunk Call/Hold
Recall
Doorphone Call
Timed
Reminder
Call Back LCS
External
Sensor
TRG1 TRG2 ... Port 1 Port 2 ...
1 Double Single Single
2 Single Double Double
:: ::::::: :::
1 280 ms*
Single
Double
Triple
S-Double