Panasonic KX-TDA30

1.1 Incoming Call Features
Feature Guide 17
*: Enable (default); : Enable
2. Distribution Method
One of the following methods can be assigned to each trunk port:
3. Destination Change with the Caller's Identification Number
The Calling Line Identification (CLI) Distribution feature works in conjunction with the DIL/DID/DDI/MSN
features.
BRI/PRI CO
*
Extension
QSIG-Master
*
QSIG-Slave
*
IP-GW —
*
*1
:
→ 1.30.1 TIE Line Service
*2
:
→ 1.30.3 Virtual Private Network (VPN)
Method Description & Reference
Direct In Line (DIL) Directs a call to a preprogrammed single destination (e.g., the
operator).
→ 1.1.1.2 Direct In Line (DIL)
Direct Inward Dialling (DID) Directs a call with a DID number from a DID line to a preprogrammed
destination.
DID is also known as Direct Dialling In (DDI).
→ 1.1.1.3 Direct Inward Dialling (DID)/Direct Dialling In (DDI)
Multiple Subscriber Number
(MSN) Ringing Service
Directs a call with an MSN from an ISDN line to a preprogrammed
destination.
→ 1.1.1.4 Multiple Subscriber Number (MSN) Ringing Service
Feature Description & Reference
Calling Line Identification
(CLI) Distribution
Directs a call to a CLI destination if the caller's identification number
has been assigned in the Caller ID Table.
→ 1.1.1.5 Calling Line Identification (CLI) Distribution
Trunk Card Type Channel Type
Networking Type
Public (DIL/DID/
DDI/MSN)
Private (TIE)*
1
Virtual Private
Network (VPN)*
2