Panasonic KX-TDA30

1.13 Holding Features
Feature Guide 177
• SLT Hold Mode
It is possible to choose how to hold a line and transfer a call with an SLT in the following methods
through system programming:
If the following occurs frequently with an SLT, choose "Mode 2", "Mode 3", or "Mode 4":
a) When an SLT user receives a call, reorder tone is heard or nobody answers the call.
b) When an SLT user goes off-hook, reorder tone is heard instead of a dial tone.
If a call is not terminated after going on-hook, the above cases occur. To avoid these problems, choose
"Mode 2", "Mode 3", or "Mode 4". Every call will be terminated unless the Hold feature number is
entered after flashing the hookswitch in Mode 2, Mode 3, and Mode 4.
• Hold Alarm tone pattern has a default. (→ 3.3.1 Tones/Ring Tones).
Hold
Hold
(to be Retrieved from
Another Extension)
*
Transfer to Trunk
Transfer to
Extension
Mode 1
Flashing the
hookswitch
+
Going on-hook
Flashing the hookswitch
+
Hold Feature No.
+
Going on-hook
Flashing the
hookswitch
+
Trunk Access No.
Flashing the
hookswitch
+
Extension No.
Mode 2
(Default)
Flashing the
hookswitch
+
Hold Feature No.
+
Going on-hook
Flashing the hookswitch
+
Hold Feature No.
+
Going on-hook
Flashing the
hookswitch
+
Trunk Access No.
Flashing the
hookswitch
+
Extension No.
Mode 3
Flashing the
hookswitch
+
Hold Feature No.
+
Going on-hook
Flashing the hookswitch
+
Hold Feature No.
+
Hold Feature No.
+
Going on-hook
Flashing the
hookswitch
+
Hold Feature No.
+
Trunk Access No.
Flashing the
hookswitch
+
Extension No.
Mode 4
Flashing the
hookswitch
+
Hold Feature No.
+
Going on-hook
Flashing the hookswitch
+
Hold Feature No.
+
Hold Feature No.
+
Going on-hook
Flashing the
hookswitch
+
Hold Feature No.
+
Trunk Access No.
Flashing the
hookswitch
+
Hold Feature No.
+
Extension No.
*: These operations must be performed when the held call is intended to be retrieved from another
extension using the holding extension number.