Panasonic KX-TDA30

1.17 Optional Device Features
222 Feature Guide
• If the destination of a sensor call has set FWD, the sensor call will be redirected to the FWD destination.
However, if the FWD destination is not supported as the destination of a sensor call (e.g., an outside
party), the call will be received at the original destination. (→ 1.3.1.2 Call Forwarding (FWD))
• The following features cannot be used when a sensor call is received:
– Alternate Receiving—Voice (→ 1.5.3 Intercom Call)
– Hands-free Answerback (→ 1.4.1.4 Hands-free Answerback)
– Consultation Hold/Call Hold (→ 1.13.1 Call Hold)
– Call Transfer (→ 1.12.1 Call Transfer)
– Executive Busy Override (→ 1.8.2 Executive Busy Override)
• Sensor call information is output on SMDR.
Installation Manual References
KX-TDA30
2.5.1 DPH4 Card (KX-TDA3161)
2.5.2 DPH2 Card (KX-TDA3162)
2.9.1 Connection of Doorphones, Door Openers, External Sensors, and External Relays
KX-TDA100/KX-TDA200
2.6.1 OPB3 Card (KX-TDA0190)
2.6.4 EIO4 Card (KX-TDA0164)
2.10.1 Connection of Doorphones, Door Openers, External Sensors, and External Relays
KX-TDA600
2.8.1 OPB3 Card (KX-TDA0190)
2.8.4 EIO4 Card (KX-TDA0164)
2.12.1 Connection of Doorphones, Door Openers, External Sensors, and External Relays
Programming Manual References
PC Programming Manual
2.7.39 [1-1] Slot—OPB (KX-TDA100/KX-TDA200/KX-TDA600 only)
→Input Signal Decision Time
→Input Signal Detection Reopening Time
2.7.43 [1-1] Slot—DPH Card Property (KX-TDA30 only)
→For Sensor (EIO)—Input Signal Decision Time
→For Sensor (EIO)—Input Signal Detection Reopening Time
2.8.4 [2-3] Timers & Counters—Miscellaneous—External Sensor—Ring Duration
2.8.16 [2-8-3] Ring Tone Patterns—Call from Others—External Sensor—Ring Tone Pattern Plan 1–8
2.11.7 [5-5] External Sensor
PT Programming Manual
None