1.22 E1 Line Service Features
Feature Guide 271
Conditions
• If an E1 line is used as a trunk, the channel type depends on the contract with the telephone company.
• If "MFC-R2" is selected as the Dial Mode, the PBX always sends a dial tone, instead of the telephone
company, when making a trunk call using E1 line.
Programming Manual References
PC Programming Manual
2.7.25 [1-1] Slot—E1 Port
2.7.26 [1-1] Slot—E1 Port—Channel Command
PT Programming Manual
None
Feature Guide References
3.2 Exclusive Features Table
(4) Automatic Number
Identification (ANI)
Outgoing ANI:
Sends the caller's number to the E1 line. The sending
method is the same as ISDN CLIP service. (→ 1.21.1.2
Calling/Connected Line Identification Presentation (CLIP/
COLP))
Incoming ANI:
Receives the caller's number from the E1 line.
When the ANI number is received, it can be treated the same
as a Caller ID number. (→ 1.18.1 Caller ID)
(5) Call Charge Information The call charge meter pulses can be received during a
conversation. (→ 1.26.3 Call Charge Services)
Number in
the table
Feature Description
To Next Page
Loading...
