1.24 Voice Mail Features
Feature Guide 285
his mailbox without dialling his mailbox number (Direct Mailbox Access). It is possible to disable this
feature by COS programming on the VPS.
7. VPS Trunk Service & Automatic Time Mode Notification for Incoming Call*
Multiple tenants can share a single VPS; each tenant does not require a dedicated VPS port. If the
destination of the incoming trunk call is a VM (DPT) group, the PBX sends the VPS trunk group number
and time mode (day/lunch/break/night) of the tenant (→ 2.2.4 Time Service) assigned for the call to the
VPS. Therefore the VPS can send the assigned message (company greeting) to the caller.
Corresponding VPS trunk group number and tenant number are determined by the setting of the
incoming trunk call as follows:
a) DIL/TIE: the setting of each trunk port (→ 1.1.1.2 Direct In Line (DIL), 1.30.1 TIE Line Service)
2.16.2 [10-2] DIL Table & Port Settings—DIL
→ Tenant Number
→ VM Trunk Group
b) DID/DDI: the setting of each location number for DID/DDI (→ 1.1.1.3 Direct Inward Dialling
(DID)/Direct Dialling In (DDI))
2.16.3 [10-3] DDI / DID Table
→ Tenant Number
→ VM Trunk Group No.
c) MSN: the setting of each MSN (→ 1.1.1.4 Multiple Subscriber Number (MSN) Ringing
Service)
2.16.6 [10-4] MSN Table—Main
→ Tenant Number
→ VM Trunk Group No.
To Next Page
Loading...
