Panasonic KX-TDA30

2.2 System Configuration—Software
Feature Guide 407
[Programming Examples of DID/DDI Table and DIL Table]
DID/DDI table can be programmed for each DID/DDI number, and a tenant (Time Table) number is
assigned to each DID/DDI number. DIL table can be programmed for each trunk, and a tenant (Time
Table) number is assigned to each trunk.
<DID/DDI Table>
<DIL Table>
Explanation:
If a trunk call with a DID number (123-4567) is received at 20:00;
1) Tenant (Time Table) number 1 will be used.
2) The call is received during night mode in Time Table 1.
3) The call will be routed to the extension 100 (VPS).
4. Holiday Mode
The holiday mode activates automatically using the Automatic Switching mode. Up to 24 holidays (start
and end dates) can be stored, and one time mode can be selected for all holidays.
5. Time Service Button
A flexible button can be customised as the following buttons:
a) Day/Night button
b) Day/Night/Lunch button
c) Day/Night/Break button
d) Day/Night/Lunch/Break button
Each of these buttons is used for switching between modes. For example, pressing the Day/Night
button switches between day and night modes. All of these buttons show the current status as follows:
Location DID/DDI No. Tenant (Time
Table) No.
DID/DDI Destination
Day Lunch Break Night
001 123-4567 1 105 100 (VPS) 105 100 (VPS)
002 123-2468 1 102 100 (VPS) 102 100 (VPS)
: : : ::::
Trunk No. Tenant (Time Table) No. DIL Destination
Day Lunch Break Night
01 1 101 100 (VPS) 101 100 (VPS)
02 2 102 100 (VPS) 102 100 (VPS)
: : ::::
Light Pattern Status
Off Day mode
Red on Night mode
Green on Lunch mode
Slow green flashing Break mode