Incident light
intensity for P-3.
Press the
Jog switch.
OFF or ON level 1_SL
ON or OFF level 2_SL
The symbol ‘
’ will be
displayed repeatedly.
Press the
MODE key 5 times.
Upper and lower limits have
not been correctly set.
The status condition (C) when incident light
is the greatest intensity.
6The amplifier has entered the ‘P-3’ setting state and ‘ ’
(green) will blink.
7If the [Jog switch] is pressed while in the status condition (C)
when the incident light is the greatest intensity, then the
display will blink and indicate the incident light intensity
reading (red).
9Then the setting for ‘ON or OFF level 2_SL’ (green) will be
displayed.
0By pressing the [MODE key] 5 times, the amplifier will return
to ‘RUN mode’ (normal sensing operation).
‘OFF or ON level 1_SL’ (green) and incident light intensity
(red) will be displayed.
8The display will indicate whether the ON and OFF level have
been correctly set and the setting for ‘OFF or ON level 1_SL’
(green) will be displayed.
• If ‘ ’ (red) is blinking…the ON and OFF level have
been set correctly.
• If ‘ ’ (red) is blinking…the ON and OFF level have not
been set correctly.
To Next Page
Loading...
