100 VQT2R24 VQT2R24 101
For [REC] menu setting procedures (→20)
Using [REC]/[MOTION PICTURE] menu
(Continued)
[I.EXPOSURE]
Automatically adjusts contrast and exposure to give more lifelike colours when there is
significant contrast between background and subject.
■
Recording mode: → [REC] menu
→ [REC] menu
■
Settings: [OFF]/[LOW]/[STANDARD]/[HIGH]
(When recording motion pictures, the available settings are [OFF]/[ON].
)
●
[LOW], [STANDARD] and [HIGH] indicate the amount of correction.
●
If the setting is other than [OFF], is displayed on the screen.
●
When [I.EXPOSURE] works, the colour of changes.
●
Even if [SENSITIVITY] is set to [80] or [100], when [I.EXPOSURE] is activated, pictures
may be taken at a higher sensitivity than the setting.
●
Correction effects may not be achieved under certain conditions.
[MIN. SHTR SPEED]
Sets shutter speed to minimum. We recommend using slower shutter speeds to take
brighter pictures in dark locations.
■
Recording mode: → [REC] menu
■
Settings: [AUTO] [1/250] [1/125] [1/60] [1/30] [1/15] [1/8] [1/4] [1/2] [1]
●
Slower shutter speeds allow for brighter pictures but increase risk of jitter, so we
recommend using a tripod and the self-timer.
●
As still pictures may become dark when using faster values such as [1/250], we
recommend that still pictures are taken in bright locations ( flashes red when shutter
button is half-pressed if still picture will be dark).
●
displayed on screen for settings other than [AUTO].
[BURST]
Enables a rapid succession of still pictures to be taken. Succession of still pictures taken
while shutter button is held down.
■
Recording mode: → [REC] menu
■
Settings:
[BURST] setting
Speed No. of pictures
∗
[OFF]
No burst
(Burst)
2.3 pictures/sec.
Fine: Max. 3
Standard: Max. 5
∗
When using self-timer: Fixed at 3 pictures
●
Focus, exposure and white balance are fixed in the first picture.
●
Burst speed may be reduced if [SENSITIVITY] is set to high, or if shutter speed is
reduced in darker locations.
●
When burst setting is used, flash is set to [FORCED FLASH OFF], and [AUTO
BRACKET], [MULTI ASPECT], and [AUDIO REC.] settings are cancelled.
●
When burst is performed with the built-in memory, writing will take some time.
●
Settings will be stored even if power is turned off.
●
Auto review performed regardless of [AUTO REVIEW] setting.
●
Burst is not available in the scene modes [TRANSFORM], [PANORAMA ASSIST], [HI-
SPEED BURST], [FLASH BURST], [STARRY SKY], [PIN HOLE], [FILM GRAIN], [HIGH
DYNAMIC],and [PHOTO FRAME].
●
Using the [HI-SPEED BURST] scene mode allows a faster succession of still pictures to
be taken. [FLASH BURST] is convenient to take continuous still pictures using flash in
dark places.
[I.RESOLUTION]
Super resolution technology can be used to record still pictures with sharper outlines.
Also, when [iA ZOOM] is set, pictures with a zoom ratio of about 1.3 can be recorded with
almost no deterioration of picture quality.
■
Recording mode:
■
Settings: [OFF]/[ON]/[iA ZOOM]
●
The iA Zoom functions in the following cases.
• ([INTELLIGENT AUTO] Mode)
• Scene modes (except for [HIGH SENS.], [FLASH BURST], [HI-SPEED BURST])
• ([CLIPBOARD] Mode)
To Next Page
Loading...
