Panasonic PT-EX620 - Page 101

Chapter 4 Settings — [PROJECTOR SETUP] menu
ENGLISH - 101
f
The [SCHEDULE] screen is displayed.
3) Press as to select [PROGRAM EDIT].
4) Press qw to select a program number, and press the <ENTER> button.
5) Press as to select a command number, and press the <ENTER> button.
6) Press asqw to select [TIME], and press the <ENTER> button.
f
The projector is in the adjustment mode (where the time is blinking).
7) Press qw to select “hour” or “minute”, and press as to set a time, and then press the <ENTER>
button.
8) Press asqw to select [COMMAND].
9) Press the <ENTER> button.
f
The [COMMAND] detailed screen is displayed.
10) Press as to select a [COMMAND].
f
For [COMMAND] which requires detailed settings, the items of the detailed settings will switch each time
you press
qw
.
f
When [INPUT] is selected, press the <ENTER> button, and then press
as
to select the input to be set.
[COMMAND]
Detailed settings of
[COMMAND]
Description
[POWER ON] ― Switches on the projector.
[STANDBY] ― Enters standby.
[SHUTTER]
*1
[OPEN] Disables the shutter function (shutter: open).
[CLOSE] Enables the shutter function (shutter: closed).
[AV MUTE]
*2
[OFF] Cancels the AV mute.
[ON] The image and the audio disappear.
[INPUT]
[NETWORK] Switches the input to NETWORK.
[RGB1] Switches the input to RGB1.
[RGB2] Switches the input to RGB2.
[HDMI1] Switches the input to HDMI1.
[HDMI2] Switches the input to HDMI2.
[VIDEO] Switches the input to VIDEO.
[DIGITAL LINK]
*1
Switches the input to DIGITAL LINK.
[INPUT1] - [INPUT10]
*3
Switches the input to DIGITAL LINK, and switch the input of the
Panasonic twisted-pair-cable transmitter to the specied input.
[LAMP POWER]
[NORMAL] Sets the lamp brightness to high luminance.
[ECO] Sets the lamp brightness to low luminance.
[IN STANDBY MODE]
[OFF] Audio output is stopped during standby.
[ON] Audio is output during standby.
[VOLUME] [0] ~ [63] Sets the volume.
*1 For PT-EZ590, PT-EW650 and PT-EX620
*2 For PT-EW550 and PT-EX520
*3 When the optional DIGITAL LINK output supported device (Model No.: ET-YFB100G, ET-YFB200G) is connected to the projector, its input
name is automatically reected from [INPUT1] to [INPUT10]. If an item where the input name is not reected is selected, it is disabled.
11) Press the <ENTER> button.
f
The command is xed and
n
is displayed at the left of the selected command.
12) Press asqw to select [STORE], and press the <ENTER> button.
Note
f
If you attempt to register the setting that would make the lamp turn on for a short time, an error message will be displayed on the screen. Set
the time and the command again.
f
To delete a command that has been already set, press the <DEFAULT> button on the remote control while the screen in Step 5) is
displayed, or select [DELETE] at the screen in Step 6) and press the <ENTER> button.
f
If multiple commands have been set for the same time, they are executed in chronological order starting from the smallest command
number.
f
The operating time will be the local time. (
x
page 102)