Chapter 4
Settings — [PROJECTOR SETUP] menu
98 - ENGLISH
Note
f
Audio is output from the built-in speaker even if the cable is connected to the <VARIABLE AUDIO OUT> terminal. To output audio from
external audio devices connected to the <VARIABLE AUDIO OUT> terminal and not from the built-in speaker, set [BUILT-IN SP] to [OFF].
Setting the audio output during standby
1) Press as to select [AUDIO SETTING].
2) Press the <ENTER> button.
f
The [AUDIO SETTING] screen is displayed.
3) Press as to select [IN STANDBY MODE].
4) Press qw to switch the item.
f
The items will switch each time you press the button.
[OFF] Disables audio output in the standby mode.
[ON]
Enables audio output in the standby mode when [STANDBY MODE] is set to [NORMAL]. At this
time, press the <VOL-> button/<VOL+> button on the remote control or the control panel to adjust
the volume.
Note
f
When [ECO MANAGEMENT] → [STANDBY MODE] is set to [ECO] (
x
page 94), even if [IN STANDBY MODE] is set to [ON], audio
cannot be output during standby.
f
When the input signal is [NETWORK], even if [IN STANDBY MODE] is set to [ON], audio cannot be output during standby.
f
When [IN STANDBY MODE] is set to [ON] and the digital signal is input, the audio output is interrupted during the cooling period after the
power is turned off, but this is not a malfunction.
Setting the mute
1) Press as to select [AUDIO SETTING].
2) Press the <ENTER> button.
f
The [AUDIO SETTING] screen is displayed.
3) Press as to select [MUTE].
4) Press qw to switch the item.
f
The items will switch each time you press the button.
[OFF] Audio is output.
[ON] Audio is not output.
Setting audio input selection
Choose the audio input terminal for each input signal.
1) Press as to select [AUDIO SETTING].
2) Press the <ENTER> button.
f
The [AUDIO SETTING] screen is displayed.
3) Press as to select one item of [AUDIO IN SELECT].
[RGB1] Set the audio output when [RGB1] input is selected.
[RGB2] Set the audio output when [RGB2] input is selected.
[VIDEO] Set the audio output when [VIDEO] input is selected.
[HDMI1] Set the audio output when [HDMI1] input is selected.
[HDMI2] Set the audio output when [HDMI2] input is selected.
[DIGITAL LINK]
*1
Set the audio output when [DIGITAL LINK] input is selected.
[NETWORK] Set the audio output when [NETWORK] input is selected.
*1 Only for PT-EZ590, PT-EW650 and PT-EX620
4) Press qw to switch the item.
To Next Page
Loading...
