Panasonic PT-EX620

Chapter 4 Settings — [PICTURE] menu
ENGLISH - 69
Items Operation Adjustment Adjustment range
[BRIGHTNESS G]
Press the w button.
Emphasizes green in shadow areas.
-32 ~ +32
Press the q button.
Deemphasizes green in shadow areas.
[BRIGHTNESS B]
Press the w button.
Emphasizes blue in shadow areas.
-32 ~ +32
Press the q button.
Deemphasizes blue in shadow areas.
[DAYLIGHT VIEW]
You can correct the image to the optimal vividness even if it is projected under a bright light.
1) Press as to select [DAYLIGHT VIEW].
2) Press qw or the <ENTER> button.
f
The [DAYLIGHT VIEW] individual adjustment screen is displayed.
3) Press qw to switch the item.
f
The items will switch each time you press the button.
[AUTO]
The brightness of the installation environment is detected by the luminance sensor, and the vividness
of the image is automatically corrected.
[OFF] No correction.
[1] Corrects the image to weaken vividness.
[2] Corrects the image to medium vividness.
[3] Corrects the image to high vividness.
Note
f
When [PROJECTION METHOD] (
x
page 93) is set to [REAR/DESK] or [REAR/CEILING], [AUTO] cannot be selected.
f
When objects, etc. are placed on the top of the projector, the illuminance sensor enters the shadow and the [AUTO] mode may not function
properly.
f
When [PICTURE MODE] is set to [DICOM SIM.], the factory default setting of the [DAYLIGHT VIEW] is [OFF] and the setting values in the
menu screen display in gray.
f
When [DAYLIGHT VIEW] is set to [AUTO], [1], [2] or [3], the [SHARPNESS] cannot be adjusted.
[DIGITAL CINEMA REALITY]
You can increase the vertical resolution and enhance the image quality by performing cinema processing when
the PAL (or SECAM) 576i signal, the NTSC 480i signal, and 1080/50i, 1080/60i are input.
1) Press as to select [DIGITAL CINEMA REALITY].
2) Press qw or the <ENTER> button.
f
The [DIGITAL CINEMA REALITY] individual adjustment screen is displayed.
3) Press qw to switch the item.
f
The items will switch each time you press the button.
[ON] Performs cinema processing.
[OFF] Does not perform cinema processing.
[NOISE REDUCTION]
(Only when the <VIDEO IN> terminal or <RGB 1 IN>
*1
terminal is selected)
You can reduce noises when the input image is degraded and noise is occurring in the image signal.
1) Press as to select [NOISE REDUCTION].
2) Press qw or the <ENTER> button.
f
The [NOISE REDUCTION] individual adjustment screen is displayed.
3) Press qw to switch the item.
f
The items will switch each time you press the button.
[OFF] No correction.
[1] Slightly corrects the noise.
[2] Moderately corrects the noise.
[3] Strongly corrects the noise.