Chapter 4
Settings — [SECURITY] menu
104 - ENGLISH
[SECURITY] menu
On the menu screen, select [SECURITY] from the main menu, and select an item from the sub-menu.
Refer to “Navigating through the menu” (
x
page 62) for the operation of the menu screen.
f
When the projector is used for the rst time
Initial password: Press
awsqawsq
in order, and press the <ENTER> button.
Attention
f
When you select the [SECURITY] menu and press the <ENTER> button, entering a password is required. Enter the preset password and
then continue operations of the [SECURITY] menu.
f
When the password has been changed previously, enter the changed password, and press the <ENTER> button.
Note
f
The entered password is displayed with * marks on the screen.
f
An error message is displayed on the screen when the entered password is incorrect. Re-enter the correct password.
[PASSWORD]
The [PASSWORD] screen is displayed when turning the <MAIN POWER> switch to <OFF> and turning on the
power. When the entered password is incorrect, the operation will be restricted to the power <
v
/
b
> button and the
<LENS> (<FOCUS>, <ZOOM> and <SHIFT>) buttons.
1) Press as to select [PASSWORD].
2) Press qw to switch the item.
f
The items will switch each time you press the button.
[OFF] Disables the security password entry.
[ON] Enables the security password entry.
Note
f
The [PASSWORD] setting is set to [OFF] by the factory default or when [INITIALIZE ALL] in [PROJECTOR SETUP] menu (
x
page 103) is
executed.
f
Change the password periodically that is hard to guess.
f
The security password is enabled after setting [PASSWORD] to [ON] and turning the <MAIN POWER> switch to <OFF>.
[PASSWORD CHANGE]
Change the security password.
1) Press as to select [PASSWORD CHANGE].
2) Press the <ENTER> button.
f
The [PASSWORD CHANGE] screen is displayed.
3) Press asqw and the number (<0> - <9>) buttons to set the password.
f
Up to eight button operations can be set.
4) Press the <ENTER> button.
5) Re-enter the password for the confirmation.
6) Press the <ENTER> button.
Note
f
The entered password is displayed with * marks on the screen.
f
An error message is displayed on the screen when the entered password is incorrect. Re-enter the correct password.
f
If numbers have been used for the security password, the security password will need to be initialized again if the remote control is lost.
Consult your dealer for the initialization method.
[DISPLAY SETTING]
Overlap the security message (text or image) over the projecting image.
1) Press as to select [DISPLAY SETTING].
2) Press qw to switch the item.
To Next Page
Loading...
