Panasonic PT-EX620 - [Digital Link Menu]; [Projector Name]; [Wired Lan]

Chapter 4 Settings — [NETWORK] menu
108 - ENGLISH
[SIGNAL QUALITY]
[SIGNAL QUALITY] is a numerical value of the amount of error, and the display color changes to
green, yellow, or red depending on that value.
Check the signal quality level while receiving a signal from the twisted-pair-cable transmitter.
f
MAX/MIN: Maximum/minimum value of the amount of error.
f
Green (
- 12 dB or lower)
→
Normal signal quality level.
f
Yellow (
- 11 to - 8 dB)
→
Warning level where there is the possibility of noise introduced on the
screen.
f
Red (
- 7 dB or higher)
→
Abnormal level where synchronization may be interrupted or a signal may
not be received.
[DIGITAL LINK MENU]
(Only for PT-EZ590, PT-EW650 and PT-EX620)
When the optional DIGITAL LINK output supported device (Model No.: ET-YFB100G, ET-YFB200G) is connected
to the <DIGITAL LINK/LAN> terminal, the main menu of DIGITAL LINK output supported device is displayed.
Refer to the Operating Instructions of the DIGITAL LINK output supported device for details.
Note
f
When [NETWORK] menu → [NETWORK CONTROL] → [EXTRON XTP] is set to [ON], [DIGITAL LINK MENU] cannot be selected.
[WIRED LAN]
You can make detailed wired LAN settings.
1) Press as to select [WIRED LAN].
2) Press the <ENTER> button.
f
The [WIRED DETAILED SETUP] screen is displayed.
3) Press as to select an item, and change the setting according to the instructions.
[DHCP]
[ON]
If a DHCP server exists in the network to which the
projector is connected, the IP address will automatically be
acquired.
[OFF]
If a DHCP server does not exist in the network to which
the projector is connected, additionally set [IP ADDRESS],
[SUBNET MASK] and [DEFAULT GATEWAY].
[IP ADDRESS] Enter the IP address if DHCP server is not used.
[SUBNET MASK] Enter the subnet mask if DHCP server is not used.
[DEFAULT GATEWAY] Enter the gateway address if DHCP server is not used.
[DNS1] Enter the preferred DNS server address if DHCP server is not used.
[DNS2] Enter the alternate DNS server address if DHCP server is not used.
4) Press as to select [OK], and press the <ENTER> button.
r
Default settings of [WIRED LAN]
f
The following settings are set before the projector leaves the factory.
[DHCP] OFF
[IP ADDRESS] 192.168.10.100
[SUBNET MASK] 255.255.255.0
[DEFAULT GATEWAY] 192.168.10.1
[DNS1]/[DNS2] NONE
Note
f
Before using the DHCP server, make sure the DHCP server is already functioning.
f
Consult your network administrator regarding the IP ADDRESS, SUBNET MASK and DEFAULT GATEWAY.
f
The settings of network are same for both the <LAN> terminal and the <DIGITAL LINK/LAN> terminal.
[PROJECTOR NAME]
Change the name as desired in such a case as the projector needs to be identied on application software.
1) Press as to select [PROJECTOR NAME].