Chapter 2
Getting Started — Connecting
42 - ENGLISH
Connecting example: Computers
Computer
Computer
Computer
Optional wireless module
(Model No.: ET-WML100)
Control computer
Control computer
Audio equipment
Attention
f
When connecting the projector to a computer or an external device, use the power cord supplied with each device and commercially
available shielded cables.
Note
f
For an HDMI cable, use an HDMI High Speed cable that conforms to HDMI standards. If a cable that does not conform to HDMI standards
is used, images may be interrupted or may not be displayed.
f
The <HDMI 1 IN> terminal/<HDMI 2 IN> terminal of the projector can be connected to an external device with a DVI-D terminal by using an
HDMI/DVI conversion cable, but some devices may not project the image properly or function properly.
f
When inputting the SYNC ON GREEN signal, do not input sync signals to the <SYNC/HD> terminal or the <VD> terminal.
f
If you operate the projector using the computer with the resume feature (last memory), you may have to reset the resume feature to operate
the projector.
f
If the [AUDIO IN SELECT] settings are incorrect, the projector may have malfunctions such as the absence of audio.
Connecting example using DIGITAL LINK
(Only for PT-EZ590, PT-EW650 and PT-EX620)
Twisted-pair-cable transmitters based on the communication standard HDBaseT
TM
such as the optional DIGITAL
LINK output supported device (Model No.: ET-YFB100G, ET-YFB200G) use twisted pair cables to transmit input
images, Ethernet, and serial control signals, and the projector can input those digital signals to the <DIGITAL
LINK/LAN> terminal.
To Next Page
Loading...
