Chapter 4
Settings — [DISPLAY OPTION] menu
90 - ENGLISH
Setting the countdown timer
1) Press as to select [P-TIMER].
2) Press the <ENTER> button.
f
The [P-TIMER] screen is displayed.
3) Press as to select [TIMER].
4) Press qw to set the time.
f
The time can be set in 1-minute increments from 1 to 180 minutes.
f
The factory default value is 10 minutes.
Note
f
[TIMER] is enabled when [MODE] is set to [COUNT DOWN].
Using the presentation timer
1) Press as to select [P-TIMER].
2) Press the <ENTER> button.
f
The [P-TIMER] screen is displayed.
3) Press as to select the item, and press the <ENTER> button.
[START] The count is started.
[STOP] The count is stopped.
[RESTART] The count is resumed.
[RESET] The count is reset.
f
When [START] or [RESTART] is selected, the elapsed time or the remaining time is displayed at the bottom
right of the projected image.
f
When [STOP] is selected, the elapsed time or the remaining time when the count was stopped is displayed
at the bottom right of the projected image.
f
When [RESET] is selected, proceed to Step 4).
4) Press the <MENU> button three times, then menu screen will disappear.
f
The P-TIMER function is cancelled.
Note
f
Presentation timer operations are also possible by the <P-TIMER> button on the remote control. (
x
page 57)
f
The security message set in the [SECURITY] menu
→
[DISPLAY SETTING] (
x
page 104) is not displayed when the elapsed time or
remaining time is displayed.
f
The elapsed time or remaining time are not displayed when the menu screen is displayed.
f
The start time becomes “000:00” when [MODE] is set to [COUNT UP].
f
When [MODE] is set to [COUNT DOWN], the start time becomes the value set at [TIMER].
f
The time gauge turns clockwise when [COUNT UP] is set, and turns counterclockwise when [COUNT DOWN] is set.
Ending the presentation timer
1) Press as to select [P-TIMER].
2) Press the <ENTER> button.
f
The [P-TIMER] screen is displayed.
3) Press as to select [EXIT].
4) Press the <ENTER> button.
[OTHER FUNCTIONS]
You can perform some of the remote control button operations by using the sub-menu.
1) Press as to select [OTHER FUNCTIONS].
To Next Page
Loading...
