Chapter 4
Settings — [PROJECTOR SETUP] menu
100 - ENGLISH
1) Press as to select [FILTER COUNTER].
2) Press the <ENTER> button.
f
The [FILTER COUNTER] screen is displayed.
3) Press as to select [TIMER].
4) Press qw to switch the setting of the timer.
f
The items will switch each time you press the button.
[OFF] Sets when you do not want to display the set time reaching alert message.
[1000 H] ~ [15000 H] Sets the timer in 1 000 hour increments from 1 000 to 15 000 hours.
Resetting [FILTER COUNTER]
1) Press as to select [FILTER COUNTER].
2) Press the <ENTER> button.
f
The [FILTER COUNTER] screen is displayed.
3) Press as to select [FILTER COUNTER RESET].
4) Press the <ENTER> button.
f
The [FILTER COUNTER RESET] screen is displayed.
5) Press qw to select [OK] and then press the <ENTER> button.
[SCHEDULE]
Set the command execution schedule for each day of the week.
Enable/Disable the schedule function
1) Press as to select [SCHEDULE].
2) Press qw to switch the item.
f
The items will switch each time you press the button.
[OFF] Disables the schedule function.
[ON]
Enables the schedule function. Refer to “How to assign a program” (x page 100) or “How to set a
program” (x page 100) for how to set the schedule.
Note
f
When [SCHEDULE] is set to [ON], the [STANDBY MODE] setting is forcibly switched to [NORMAL], and the setting cannot be changed.
Even if [SCHEDULE] is then set to [OFF] when in this state, the setting of [STANDBY MODE] remains at [NORMAL].
How to assign a program
1) Press as to select [SCHEDULE].
2) Press qw to select [ON], and press the <ENTER> button.
f
The [SCHEDULE] screen is displayed.
3) Select and assign program to each day of week.
f
Press
as
to select the day of week, and press
qw
to select a program number.
f
You can set the program from No.1 to No.7. “- - -” indicates that the program number has not been set.
How to set a program
Set up to 16 commands to each program.
1) Press as to select [SCHEDULE].
2) Press qw to select [ON], and press the <ENTER> button.
To Next Page
Loading...
