Panasonic PT-EX620

Chapter 7 Appendix — Technical information
154 - ENGLISH
r Lens control command
Command Sub command Details Remark
VXX LNSI2 Lens H shift
+00000=Fine adjustment 1+, +00001=Fine adjustment 1
- ,
+00100=Fine adjustment 2+, +00101=Fine adjustment 2 - ,
+00200=Coarse adjustment+, +00201=Coarse adjustment -
VXX LNSI3 Lens V shift
VXX LNSI4 Lens focus
VXX LNSI5 Lens zoom
<REMOTE 1 IN> terminal
It is possible to control the projector remotely (by external contact) from a control panel located away from the
projector where remote control signals cannot reach.
Use the <REMOTE 1 IN> terminal on the connecting terminals of the projector to connect to the control panel.
Installation locations in meeting rooms, etc. Remote control board in another location
Remote control
Contact control
Standby
Lit
Lamp
RGB1
RGB2
VIDEO
HDMI1
HDMI2
Remote control/Contact control
Pin assignments and signal names
D-Sub 9-pin
Outside view
Pin No. Signal name Open (H) Short (L)
(9) (6)
(5) (1)
(1) GND ― GND
(2) POWER OFF ON
(3) RGB1 Other RGB1
(4) RGB2 Other RGB2
(5) VIDEO Other VIDEO
(6) HDMI1 Other HDMI1
(7) HDMI2 Other HDMI2
(8) SHUTTER
*1
OFF ON
(9) RST/SET
Controlled by remote
control
Controlled by external
contact
*1 For PT-EZ590, PT-EW650 and PT-EX620
[AV MUTE] for PT-EW550 and PT-EX520
Attention
f
When controlling, make sure to short-circuit pins (1) and (9).
f
When pins (1) and (9) are short-circuited, the following buttons on the control panel and the remote control are disabled. Commands for
RS-232C and network functions corresponding to these functions are also disabled.
g
Power <
v
/
b
> button, <HDMI1> button, <HDMI2> button, <DIGITAL LINK> button, <RGB1/2> button, <VIDEO> button, <SHUTTER>
button, <AV MUTE> button and <INPUT SELECT> button
Note
f
For pin (2) to pin (8) settings, you can make changes if you set [REMOTE1 MODE] to [USER]. (
x
page 96)