Panasonic PT-EX620 - Default Chapter; [Brightness]; [Contrast]; [Picture Mode]

Chapter 4 Settings — [PICTURE] menu
66 - ENGLISH
[PICTURE] menu
On the menu screen, select [PICTURE] from the main menu, and select an item from the sub-menu.
Refer to “Navigating through the menu” (
x
page 62) for the operation of the menu screen.
[PICTURE MODE]
You can switch to the desired picture mode suitable for the image source and the environment in which the
projector is used.
1) Press as to select [PICTURE MODE].
2) Press qw or the <ENTER> button.
f
The [PICTURE MODE] individual adjustment screen is displayed.
3) Press qw to switch the item.
f
The items will switch each time you press the button.
[STANDARD] The image becomes suitable for moving images in general.
[DYNAMIC] The light output is maximized for use in bright areas.
[DICOM SIM.] The image becomes similar to that of DICOM Part 14 Grayscale Standard.
[BLACKBOARD] The image becomes suitable for projecting on a blackboard.
[WHITE BOARD] The image becomes suitable for projecting on a white board.
[CINEMA]
*1
The image becomes suitable for movie contents.
[NATURAL]
*2
The image becomes suitable for using in low-light areas.
*1 Only for movie-based input signals
*2 Only for still image input signals
Note
f
DICOM is an abbreviation of “Digital Imaging and COmmunication in Medicine” and is a standard for medical imaging devices. Although the
DICOM name is used, the projector is not a medical device, and should not be used for purposes such as diagnosis of display images.
f
When [PICTURE MODE] is set to [DICOM SIM.], the [DAYLIGHT VIEW] is xed to [OFF].
f
When [PICTURE MODE] is set to [DICOM SIM.], the [LAMP POWER] in the [PROJECTOR SETUP] menu is xed to [ECO].
[CONTRAST]
You can adjust the contrast of the colors.
1) Press as to select [CONTRAST].
2) Press qw or the <ENTER> button.
f
The [CONTRAST] individual adjustment screen is displayed.
3) Press qw to adjust the level.
Operation Adjustment Range of adjustment
Press the w button.
Brightens the screen and makes the color of image deeper.
- 32 ~ +32
Press the q button.
Darkens the screen and makes the color of image lighter.
Attention
f
Adjust [BRIGHTNESS] rst when you need to adjust [BRIGHTNESS] and [CONTRAST].
[BRIGHTNESS]
You can adjust the dark (black) part of the projected image.
1) Press as to select [BRIGHTNESS].
2) Press qw or the <ENTER> button.
f
The [BRIGHTNESS] individual adjustment screen is displayed.
3) Press qw to adjust the level.