Panasonic PT-EX620

Chapter 3 Basic Operations — Switching on/off the projector
ENGLISH - 49
3) Press the <ENTER> button.
f
Conrm the setting value and complete the initial setting.
Making adjustments and selections
It is recommended that images be projected continuously for at least 30 minutes before the focus is adjusted.
1) 8)
5)
3)
1) 5) 7) 8) 9)
6)
7) 9)
2)
4)
2)
4)
3)
1) Press the <FOCUS> button to roughly adjust the focus of the image. (x page 52)
2) Change the setting of the [PROJECTOR SETUP] menu → [PROJECTION METHOD] depending on the
installation mode. (x page 93)
f
Refer to “Navigating through the menu” (
x
page 62) for the operation of the menu screen.
3) Press the <INPUT SELECT> button on the control panel or the input selection (<HDMI1>, <HDMI2>,
<DIGITAL LINK>
*1
, <RGB1/2>, <VIDEO>, <NETWORK>) buttons on the remote control to select the
input signal.
*1 Only for PT-EZ590, PT-EW650 and PT-EX620
4) Adjust the front, back and sideway tilt of the projector with the adjustable feet. (x page 37)
5) Press the <SHIFT> button to adjust the position of the image.
6) If the input signal is the RGB signal, press the <AUTO SETUP> button.
7) Press the <ZOOM> button to adjust the size of the image to match the screen.
8) Press the <FOCUS> button again to adjust the focus.
9) Press the <ZOOM> button again to adjust the zoom and the size of the image to match the screen.
Note
f
When the projector is switched on for the rst time after purchase as well as when [INITIALIZE ALL] in the [PROJECTOR SETUP] menu is
executed, the focus adjustment screen is displayed after projection starts, then the [INITIAL SETTING] screen is displayed. Refer to “When
the initial setting screen is displayed” (
x
page 47).