Panasonic PT-EX620 - When Connecting Via Wireless LAN

Chapter 5 Operation of Function — Network connections
114 - ENGLISH
Note
f
Please conrm with your network administrator before you connect to an existing network.
f
The following settings are set before the projector leaves the factory.
[DHCP] OFF
[IP ADDRESS] 192.168.10.100
[SUBNET MASK] 255.255.255.0
[DEFAULT GATEWAY] 192.168.10.1
[DNS1]/[DNS2] NONE
Computer setting
1) Turn on the computer.
2) Make the network setting according to your system administrator.
f
If the projector settings are the default settings, the computer can be used with the following network
settings.
[IP ADDRESS] 192.168.10.101
[SUBNET MASK] 255.255.255.0
[DEFAULT GATEWAY] 192.168.10.1
When connecting via wireless LAN
The wireless module (Model No.: ET-WML100) of the optional accessories is required if you want to use the network function
through the wireless LAN.
f
Only one projector can be connected with the wireless LAN.
Connection example
IEEE802.11b/g/n
Wireless module of optional accessories
(Model No.: ET-WML100)
Preparation and conrmation of the projector
1) Turn on the projector.
2) Insert the wireless module (Model No.: ET-WML100) of optional accessories firmly into the
<WIRELESS> terminal.
Wireless module of optional
accessories
(Model No.: ET-WML100)
3) Press the <NETWORK> button to switch to NETWORK input.
f
The network input idle screen is displayed. The login password (a four-digit number that is automatically
generated), PROJECTOR NAME, SSID, IP ADDRESS (WIRELESS) and IP ADDRESS (WIRED) will be
displayed in the idle screen.
f
You can also press the <INPUT SELECT> button on the control panel and the input guide is displayed, then
press
asqw
to switch to NETWORK input.