Panasonic PT-EX620 - [Hdmi In]

Chapter 4 Settings — [DISPLAY OPTION] menu
ENGLISH - 83
f
The [VERTICAL SCAN FREQUENCY] screen is displayed.
9) Press qw to select [VERTICAL SCAN FREQUENCY].
f
Select [60Hz], [50Hz], [30Hz], [25Hz] or [24Hz] when [1920x1080p] is selected for [RESOLUTION].
f
Select [60Hz], [50Hz] or [48Hz] when [1920x1080i] is selected for [RESOLUTION].
f
The value is xed to [60Hz] when [1280x1024p], [1400x1050p], [1440x900p] or [1600x1200p] is selected
for [RESOLUTION].
f
Select [60Hz] or [50Hz] when anything other than the above signals are selected for [RESOLUTION].
10) Press the <ENTER> button.
f
The conrmation screen is displayed.
11) Press qw to select [OK], and press the <ENTER> button.
Note
f
The setting details are displayed in [RESOLUTION] and [VERTICAL SCAN FREQUENCY] below [EDID MODE].
f
The resolution and vertical scanning frequency settings may be required on your computer or video device.
f
After conguring settings, your computer or video device or the projector may be required to be restarted.
f
Output with resolution and vertical scanning frequency that have been set may not be performed depending on your computer or video
device.
f
When the image is displayed incorrectly even if the format is selected in [EDID MODE], please check the settings of [WIDE MODE] (
x
page
89) or [SXGA MODE] (
x
page 89).
[HDMI IN]
Switch the setting when the external device is connected to the <HDMI 1 IN> terminal or the <HDMI 2 IN> terminal
of the projector and the image is not projected correctly.
1) Press as to select [HDMI IN].
2) Press the <ENTER> button.
f
The [HDMI IN] screen is displayed.
3) Press as to select [SIGNAL LEVEL].
4) Press qw to switch the item.
f
The items will switch each time you press the button.
[AUTO] Sets the signal level automatically.
[64-940]
Select when the HDMI terminal of an external device (such as a blu-ray player) is connected to the <HDMI 1
IN> terminal or the <HDMI 2 IN> terminal.
[0-1023]
Select when the DVI terminal output of an external device (such as a computer) is connected to the <HDMI 1
IN> terminal or the <HDMI 2 IN> terminal via a conversion cable or similar cable.
Select also when the HDMI terminal output of a computer or other device is connected to the <HDMI 1 IN>
terminal or the <HDMI 2 IN> terminal.
Note
f
The same setting of the [SIGNAL LEVEL] is set to the <HDMI 1 IN> terminal and <HDMI 2 IN> terminal.
f
The optimal setting varies depending on the output setting of the connected external device. Refer to the operation instruction of the external
device regarding the output of the external device.
f
The displayed signal level is assumed when the input is 30 bits.
Setting [EDID MODE]
1) Press as to select [HDMI IN].
2) Press the <ENTER> button.
f
The [HDMI IN] screen is displayed.
3) Press as to select [EDID MODE].
4) Press the <ENTER> button.
f
The [HDMI EDID MODE] screen is displayed.
5) Press qw to switch [EDID MODE].
f
The items will switch each time you press the button.