Chapter 4
Settings — [PROJECTOR SETUP] menu
ENGLISH - 95
f
The [ECO MANAGEMENT] screen is displayed.
3) Press as to select [STANDBY MODE].
4) Press qw to switch the item.
f
The items will switch each time you press the button.
[NORMAL] Select this item to use the network function or the serial communication function during standby.
[ECO] Select this item to reduce power consumption during standby.
Note
f
If [STANDBY MODE] is set to [ECO], you cannot use network functions when the projector is standing by. Also, you cannot use some RS-
232C protocol commands.
f
When set to [ECO], it may take approx. 10 seconds longer before the projector starts projecting after the power is turned on, compared with
when [NORMAL] is set.
f
When set to [NORMAL], it may take approx. 1 minute to enable the network function after connecting the power cord.
f
The setting of [STANDBY MODE] cannot be returned to the factory default even if the [PROJECTOR SETUP] menu → [INITIALIZE ALL] is
executed. (
Æ
page 103)
[RS-232C]
Set the communication conditions of the <SERIAL IN> terminal.
Setting the communication condition of the <SERIAL IN> terminal
1) Press as to select [RS-232C].
2) Press the <ENTER> button.
f
The [RS-232C] screen is displayed.
f
Only for PT-EW550 and PT-EX520, proceed to step 5).
3) Press as to select [INPUT SELECT].
4) Press qw to switch the item.
[PROJECTOR] Use the <SERIAL IN> terminal of the projector to perform RS-232C communication.
[DIGITAL LINK]
Performs RS-232C communication via the DIGITAL LINK output supported device (Model No.:
ET-YFB100G, ET-YFB200G) and the <DIGITAL LINK/LAN> terminal.
5) Press as to select [BAUDRATE].
6) Press qw to switch the item.
f
The items will switch each time you press the button.
[9600]
Select the proper speed.[19200]
[38400]
7) Press as to select [PARITY].
8) Press qw to switch the item.
f
The items will switch each time you press the button.
[NONE]
Select the parity condition.[EVEN]
[ODD]
Setting the control commands of an existing projector
When controlling the projector on a computer, set use of control commands on a previously purchased Panasonic
projector. This allows the control software for an existing Panasonic projector to be inherited and used.
1) Press as to select [RS-232C].
2) Press the <ENTER> button.
f
The [RS-232C] screen is displayed.
To Next Page
Loading...
