Install Drivers for 9000 Boards
50
3.7.2. Calibration Utilities
Please see the readme file included in the driver folder.
3.8. Install PenMount WinCE Driver
Before installing PenMount WinCE Driver, you must have WinCE system installed and
running on your device. You must also have PenMount Serial Interface either 9026BH or
9036CH control boards installed.
NOTE: Make sure you can move the WinCE cursor with a serial mouse attached to the
target COM port (e.g. COM2) before connecting the 9000 control board.
3.8.1. Install PenMount WinCE Driver
Please see the readme file included in the driver folder.
To Next Page
Loading...