2
Chapter 2. Install PenMount 9000 Control Boards
The procedures below describe how to install and configure the hardware for each PenMount
9000 Control Board.
2.1. Installation Requirements
You need the following to install a touch screen using a PenMount 9000 Touch screen
Control Board:
2.1.1. Computer
- An IBM-compatible host computer
- A communications port of RS-232
- A Compact Disc drive
- One of the following operating systems installed on the computer:
Windows 3.1/95/98/ME/NT/2000/XP/2003/VISTA/7/8,
Windows CE/XPE, DOS, Linux, and QNX.
2.1.2. Touch screen
- PenMount 9026 board supports 4-wire or 8-wire tail analog resistive
touch screens.
- PenMount 9036CH board supports 4,8-wire or 5-wire tail analog
resistive touch screens.
2.1.3. Control Board
- A PenMount 9000 Touch screen Control Board
- Cables to connect the control board to the touch screen and the
computer’s communications port
- A cable to connect the power supply.
- The PenMount Drivers & Utilities disk.
To Next Page
Loading...