Pentair Fleck 5800 LXT - Optical Sensor Replacement

Installer manual Fleck 5800 LXT - Maintenance
Ref. MKT-IM-005 / F - 30.04.2020 75 / 96
9.4.9 Optical sensor replacement
1. Remove the controller, see Controller replacement [
→
Page68].
2. Disconnect the wire from the motor to the optical sensor (4).
3. Release the optical sensor support (1) by pushing it back and up as shown.
4. Release the optical sensor (3) from its support (1) by pressing the clips (2).
5. Change the optical sensor (3).
6. Reverse above procedure steps to rebuild.