12 / 84
industrial heat tracing solutions
EN-RaychemNGC30UIT2Programming-AR-H5818602/16
SECTION 2 BASIC CONFIGURATION QUICK START
The following gives an overview of how to implement a simple 4 Circuit system. For greater detail
and PLI module configuration, please go to Section 3 – Full Configuration on page 25.
2.1 AN EXAMPLE OF A SIMPLE 4 CIRCUIT SETUP
IMPORTANT: A Configuration Spreadsheet has been developed to assist in the collection of
specific
circuit (Circuit) details. This spreadsheet is located in Appendix E.
The following is a typical heat-tracing system for a four (4) Circuit Setup:
• Four (4) pipes (Pipe #1, Pipe #2, Pipe #3, Pipe #4)
• Four (4) heaters (one per pipe: Heater #1, Heater #2, Heater #3, Heater #4)
• Four (4) output relays (Relay #1, Relay #2, Relay #3, Relay #4) which control the heater’s
contactors
• Four (4) RTD temperature sensors (RTD #1, RTD #2, RTD #3, RTD #4)
• Four (4) On/Off control modes
This is the first window that appears when the program loads.
Fig. 2.1 Main window
To Next Page
Loading...
