74 / 84
industrial heat tracing solutions
EN-RaychemNGC30UIT2Programming-AR-H5818602/16
APPENDIX F. TERMS AND DEFINITIONS
Amps Heater current amperes
Control Temperature The lowest temperature from the RTDs assigned to a Circuit
°C or °F The control temperature
DB Dead Band
Device Address Network address for specific hardware devices attached to the NGC-UIT2
EMR Electrical Mechanical Relay
G.F. Heater ground-fault current
ID Identification ‘tag’ for the Circuit
Circuit Short for ‘Control Circuit’, the basic organizing structure of the
Raychem NGC-30
RTD Resistance Temperature Detectors
RTD Number This is the number of the RTD determined by the physical point of
connection to a networked device
Set Pt Set Point is the desired maintain temperature
SSR Solid State Relay
Status Relay (heater on, off or trip) and communication status
Table F.1
Data Entry Type Description
Entry Window In Setup Windows, any white entry box will populate via a pop-up
entry window
Entry List Allows choices from a list of data
Action Button Prompts before performing a task
Toggle Button Toggles between two actions
IMPORTANT: When a button’s word(s) is grayed out, no action can be taken
APPENDIX G. CONFIGURATION SPREADSHEET
An electronic version of the Raychem NGC-30 Configuration Spreadsheet is available on our web
site, www.pentairthermal.com on the NGC-30 product page under Heat Tracing. Select “Raychem
NGC-30 Configuration Spreadsheet” from the list to download.
A printed copy of the spreadsheet is available for use on the following 3 pages. However,
information will have to be manually entered into the NGC-UIT2.
Regardless of which medium you use, retain a copy for future reference or backup.
To Next Page
Loading...
